STEP 1

Create a smooth, flat surface

If needed, create a smooth, flat surface using putty followed by light sanding.

STEP 2

Apply primer on the surface

Apply the primer on the surface for better adhesion, then apply around edges and corners, and sand gently when dry. Primer application requirements vary depending on the surface. For detailed instructions, contact our technical department.

STEP 3

Measure & cut the film

Measure and cut the BODAQ interior film.

STEP 4

Peel off & pull the release backing

Peel off and pull the release backing about 4 inches and attach film, repositioning as needed until aligned correctly.

STEP 5

Adhere the film from top to bottom

Using a squeegee held at a 45-degree angle, firmly adhere the film from top to bottom using a fan-shaped sweeping motion.